Installation manual

118 Telephone Switching Systems for Amanda@SOHO
This file contains the tokens “-#*96,%E”.
• The dial codes and integration strings used by the switch are in
c:\amanda\pbx.db\230.pbx.
This file contains the following lines:
Sprint CTX/MTX
####################################################
# Sprint CTX/MTX #
####################################################
dl_dtwait F- # Dial code to put a caller on transfer hold :
dl_ndtret F- # Dial code to use when there is no transfer dialtone:
dl_rnaret F- # Dial code to return to caller after Ring No Answer :
dl_bsyret F- # Dial code to return to caller when there is a Busy :
dl_hupret F- # Dial code to use after a call screening reject :
dl_connect H # Dial code to connect the caller to the extension :
tmo_dtwait 4 # Number of seconds to wait for dialtone detection :
flashtm 55 # Number of 1/100 seconds to use for Flash time :
dt_answer # Which DTMF tone to listen to for answer detection :
dt_hangup # Which DTMF tone to listen to for hangup detection :
dl_prefix # What to dial BEFORE dialing the User ID extension :
dl_suffix H # What to dial AFTER dialing the User ID extension :
dl_init # What to dial when the system first starts up :
dl_stop # What to dial when the system performs a shutdown :
dl_pickup # What to dial when a port goes off-hook :
dl_conference # What to dial to create/record a conference call :
integration 10 ‘11rrr’
integration 10 ‘12eee’
integration 10 ‘13eee’
integration 10 ‘14iii’
integration 10 ‘21ttt’
integration 10 ‘22rrr’
integration 10 ‘ttt’