Installation manual

Chapter 2:
Programming the
AT&T Partner Plus
Getting Started
To connect Amanda to the switching system:
1. Run direct wiring from RJ-11 jack (one-pair) on Partner 206 module to RJ-11 jack
(two-pair) on the voice board.
2. Run wiring from 66 block to RJ-11 jack (two-pair) to the Amanda Rhetorex voice
board.
OR
• Use four RJ-11 mounting cords, one cord for each voice mail port. Plug one into
each extension port on the 206 Module.
The 206 Module must be 3.1 or higher in order to turn the message lights on and off
for single-line telephones.
To start programming the AT&T Partner:
•Press
.
To exit programming the AT&T Partner:
•Press
.
Programming is done only from extension 10 or 11.
Using Amanda as a Primary Automated Attendant
If you are using Amanda as a primary automated attendant, you need to read the following
sections. Many of these sections also apply to using Amanda as a backup attendant or a
voice messaging center; sometimes the settings are identical. Sometimes they are
different. Be sure to use the settings for the primary automated attendant.
Section to read: To program:
Programming Hunt Group 7 #505 Hunt Group Extensions
Assigning Extensions to Ring-
No-Answer Service
#310 VMS Cover
Setting the Number of Rings for
No Answer
#117 VMS Cover Rings
Determining When Voice Mail
Answers Calls
#506 VMS Hunt Delay