Installation manual

94 Telephone Switching Systems for Amanda@SOHO
To connect Amanda:
1. Connect these extensions to the Amanda Voice Mail unit with line cords.
2. Power up the telephone system with the rocker switch on the KSU.
3. Wait 30 seconds and power up the analog terminal adapter (plug in its power cord).
4. Power up Amanda.
The system is now ready to test.
The station user manuals for the telephones contain good descriptions for its use with
voice mail.
Initiating Programming
To program the Protegé CTX telephone system:
A working version of the Protegé programming software must be installed on a computer.
It is important to note that the software only responds to COM ports 1 and 2.
1. After installing the software, go to the computer’s root directory.
You should see the DOS prompt: C:\ or something similar.
2. Use a data cable (Sprint North Supply Part # 447854) to connect the DB9 cable
between COM1 on the computer and the DB9 plug marked MODEM on the KSU. Do
not use the SMDR port on the KSU for this connection.
3. Type S3F30 then press Enter.
The Main Menu appears.
The file c:\protege\s3f30\vmltest contains the information that is saved and restored.
N
OTE
: Different versions of Sprint CTX software require different commands
to initiate. The software installation guide should provide the proper
command.
You can also save and restore to and from drive A or the hard drive.
To begin programming, or inspection, of the “scratchpad” memory of the current
programming data:
1. From the Main menu, select RMP then press Enter.
The RMP menu appears.