Installation guide

61
4) Once the basic Portal system is running ok. From a command prompt, start telnet,
login as mailbox 999 and "source" the tcl file that was generated by migrate (as shown in
the pictures below).
To start telnet, from a command prompt type “telnet localhost” which will connect you to
the Amanda Portal telnet service (as shown below).
Login as the system administrator by typing “login 999 999” at the % prompt and
pressing enter (as shown):
Once logged in source the script file by typing “source c:/Amanda/script.tcl” and pressing
enter (as shown).
Note: The path specification that you type in should use forward slashes, not back slashes
or even double back slashes.
Important Note: When notify templates are created by the script.tcl file, all notify
templates are recreated under Amanda Portal. Keeping this in mind, mailbox 997 on
Amanda Portal has default light_on, and light_off templates which are also created when
the mailboxes are created (so you’ll end up with 4 notify templates for light on and off).