Installation guide

9
Note: If using Dialogic GammaLink fax boards, you MUST check the box “Use
GammaLink fax boards”. Due to the new availability of Dialogic JCT boards supporting
both voice and fax in one board it is unlikely GammaLink boards will be used very much
in the future.
3.7 Activating Audio Boards
Activate the Audio Boards by setting the “Number of ports to license” to the number of
ports installed in the system (i.e. for 4 ports enter 4, 8 ports enter 8, etc). The example in
figure 12 shows that 4 Brooktrout/Rhetorex ports are being installed. After entering the
appropriate number of ports, click next to continue.
Figure 12
3.8 PBX Selection
Under the PBX selection page, choose your PBX type from the list provided (as shown in
figure 13). If you will be using SMDI integration, check the “Use SMDI” box. After
selecting your PBX type, click next to continue.