Installation Instructions

5
Natural Gas Conversion
1. Turn the manual shut-off valve to the closed position.
2. Unplug range or disconnect power.
To Convert Gas Pressure Regulator (Natural Gas)
See the “Gas Conversion Instructions” section in the Installation
Instructions provided with the range for proper regulator
conversion.
To Convert Surface Burners (Natural Gas)
Surface burners do not need conversion for high altitude. Only
adjust surface burner valve. See the “Adjust Flame Height”
section.
To Convert Oven Bake Burner (Natural Gas)
Only the bake orifice needs to be converted for high altitude.
1. Remove the oven racks and the oven door. See the “Oven
Door” section in the Installation Instructions.
2. Remove 2 screws and washers at the rear of the oven
bottom.
3. Lift the rear of the oven bottom up and back until the front
of the panel is away from the front frame. Remove from
oven and set it aside on a covered surface.
4. Remove 2 screws from the bake burner.
5. Slide the front of the bake burner to the side to remove tab
from front of oven. Lift the back of the bake burner off the
oven orifice, and set the bake burner aside. Do not
disconnect the wire.
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
A
B
C
A. Gas supply line
B. Manual shut-off valve closed position
C. To range
A
B
A. Screws
B. Oven bottom
A
B
A. Bake burner
B. Screws
A
A. Oven orifice