Owner's Manual

11
RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease lters frequently
according to the following instructions. Replace the grease
lterbefore operating hood.
Exterior Surfaces
IMPORTANT: Do not use soap-lled scouring pads,
abrasivecleaners, cooktop polishing creme, steel wool,
grittywashcloths, or paper towels.
To avoid damage to the stainless steel, do not use cleaners
thatcontain chlorine.
Cleaning Method:
■ Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with a soft, lint-free cloth.
■ Glass cleaner to remove ngerprints.
■ For stainless steel models, rub in the direction of the
graintoavoid scratching or damaging the surface.
■ For stainless steel models, use Stainless Steel Cleaner
andPolish, Part Number 31462A (not included):
See the “Assistance or Service” section to order.
Metal or Charcoal Grease Filter
To Clean the Filter:
1. Remove the screw from the grease lter retainer.
2. Turn the grease lter retainer to release the lter.
3. For vented installations: Wash the metal lter as needed
ina dishwasher or hot detergent solution.
For non-vented (recirculating) installations: Replace
themetal lter with a charcoal lter. The charcoal lter is
notwashable. It should last up to 6 months with normal
use.For information on ordering, see the “Assistance
orService” section. Dispose of old charcoal lter.
To Replace the Filter:
1. To reinstall the lter, place the back edge of the lter into the
channel at the rear of the hood. Push the lter into place and
turn the lter retainer to secure the lter to the range hood.
2. Replace the screw in the grease lter retainer.
Replacing the Light Bulb
Turn off the range hood and allow the light bulb to cool.
1. Disconnect power.
2. Squeeze the plastic lens cover and remove it from the hood.
3. Screw a 120 V, 75 W maximum, light bulb with
E26baseintothe socket.
4. Replace the lens cover by squeezing the cover
andinsertingthe tabs into the slots.
5. Reconnect power.
If the new light does not operate, make sure the light bulb
isinserted correctly before calling service.
A
A. Filter retainer