product manual

Install Range Hood

1. Lift the range hood up under cabinet and determine final

location by centering beneath cabinet. Mark on the underside

of cabinet the location of the 4 keyhole mounting slots on the

range hood. Set range hood aside on a covered surface.

2. Use ¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown.

3. Install the 4 - 4.5 mm x 13 mm mounting screws in pilot

holes. Leave about ¹⁄₄" (6.4 mm) space between screw heads

and cabinet to slide range hood into place.

Non-vent (recirculating) installations - Do not remove any

knockouts.

Power Supply Cable Installation

1. For direct wire installations, run the home power supply cable

according to the National Electric Code or CSA standards

and local codes and ordinances. There must be enough

wiring from the fused disconnect (or circuit breaker) box to

make the connection in the hood electrical terminal box.

For optional power supply cord kit installations, follow the

instructions in the “Make Electrical Connections” section.

NOTE: Do not reconnect power until the installation is

complete.

2. Remove the screw from the terminal box cover. Remove

terminal box cover and set aside.

3. Remove the power supply knockout from the top or rear of

the vent hood (depending on the incoming location of your

home power supply cable) and install a UL listed or CSA

approved ¹⁄₂" strain relief.

4. Using 2 or more people, lift the hood into final position. Feed

enough electrical wire through the ½" UL listed or CSA

approved strain relief to make connections in the terminal

box. Tighten the strain relief screws.

5. Position the range hood so that the large end of the keyhole

slots are over the mounting screws. Then push the hood

toward the wall so that the screws are in the neck of the slots.

Tighten the mounting screws, making sure the screws are in

the narrow neck of slots.

A. Keyhole slot

A. Drill pilot hole

¹⁄₄"

(6.4 mm)

A. Terminal box cover

B. Screw

A. Power supply knockout