Quick Start Guide

©2019 ACP, Inc.
Cedar Rapids, IA 52404
Part No. 20267701
Original Instructions
For full product documentation visit:
www.acpsolutions.com
Quick Start Guide
Refer to Owner’s Manual for Safety Statements. Complete Owner’s Manual available online.
This document covers RMS*A and MMS*A models with dial controls
A
B
C
D
OVEN CLEARANCES
A. Allow at least 7” (17.78 cm) of clearance around top of oven. Proper air ow
around oven cools electrical components. With restricted air ow, oven may not
operate properly and life of electrical parts is reduced.
B. There is not an installation clearance requirement for the back of the oven.
C. Allow at least 1” (2.54 cm) of clearance around sides of oven.
D. Install oven so oven bottom is at least 3 feet (91.5 cm) above oor.
The switching operation of this microwave oven can cause voltage uctuations on the supply line. The operation of this oven under unfavorable
voltage supply conditions can have adverse e󰀨ects. This device is intended for the connection to a power supply system with a maximum
permissible system impedance Zmax of 0.2 Ohms at the interface point of the user’s supply. The user has to ensure that this device is connected
only to a power supply system which fullls the requirement above. If necessary, the user can ask the public power supply company for the
system impedance at the interface point.
So…how do I use it? (Dial Control)
Heating
1. Open oven door and place food in oven. Close door.
2. Turn time entry knob clockwise to desired time.
• Cooking time can be set up to 6 minutes.
• Oven begins operation and time counts down.
3. When cooking time has elapsed, microwave energy stops and oven signal sounds.
Interrupting and Stopping Operation
1. Open oven door to interrupt and stop operation or turn time entry knob
counterclockwise to “0”.
2. When cooking is interrupted by opening door, oven automatically resets to zero
time.
3. To resume microwave oven operation, close door and re-enter desired time by
turning knob clockwise.
Changing Time and Canceling Mistakes
Heating time can be changed at any time while the oven is operating. Turn knob to
desired new setting.
To set cooking time to zero, turn knob counterclockwise to “0”. Setting the time to zero
cancels the set cooking time and turns the oven o󰀨.
Refer to Owner’s Manual for complete care
and cleaning instructions.
⚠
Do NOT use abrasive cleaners or cleaners
containing ammonia, citrus, phosphates, chlorine,
sodium or potassium hydroxide (lye).
Use of unapproved cleaning agents will void
the terms of the warranty.
No metal pans
No metal pans
DO NOT power spray
DO NOT power spray