Owner`s manual

Temperature-Controlled Beverage Chiller T°
(Some models)
Temperature-Controlled Beverage Chiller" keeps
beverages up to 5°F (3°C) colder than refrigerator section.
Air inlet allows air from freezer section to pass to
Beverage Chiller TM. Air inlet is located on interior wall of
refrigerator door.
Beverage Chiller TM control is located on left front watt of
refrigerator section. Control adjusts amount of air
circulating in Beverage Chiller TM. Turn control to COLD for
normal refrigerator temperature and to COLDER for colder
temperature.
_A
A Beverage Chiller TM tempeIamre
control
B Turn control clockwise for
colder
Beverage Chillel TM flip top design
( Beverage (hilIei TM door
D All inlet
Beverage Chiller TM comes in a flip top and a roll top
design. It is adjustable to accommodate storage and
cleaning needs.
To remove Beverage Chiller TM perform the following
steps:
1. Grasp Beverage Chiller TM by sides lift up and pull out
to remove.
Note: If Beverage Chiller TM has a separate bottom
section, remove by pushing up and pulling out.
A Beverage Chiller TM bottom section
Beverage Chillei TM flip top design
To replace:
1. Slide Beverage Chiller TM bottom between desired shelf
rails in door liner and push down into place.
• If Beverage Chiller TM door track is cleaned, door
track must be lubricated with petroleum jelly for
proper operation of chiller door.
2. Slide Beverage Chi{ler TM between desired shelf rails in
door liner and push Beverage Chiller TM top down into
place over Beverage Chitter TM bottom.
ItvlPORTANT
For proper operation of Beverage Chiller TM, one of the
cold air intake holes must line up with notch in right door
dike.
A Door liner shelf rail C Flange
B Notch in dooi dike must line up D Beverage Chiller TM
with one of Beverage Chiller TM E Beverage Chiller TM Door
cold aiI intake holes
Beverage Chiller TM rolI top and flip top designs
Remove Beverage Chiller TM cover (flip top model
only) by opening cover. Push cover inward at pivot
points and pull cover out. Replace cover by reversing
procedure.
A
c _
A Beverage ChillerTM top ( Beverage ChilleiTM
B Beverage ChillerTM cover bottom
Beverage ChillerTM flip top design
Door Buckets and Shelves
Graphic below does not represent all available bucket and
shelf designs, however the following instructions do apply to
all units.
Door buckets adjust to meet individual storage needs.
• Remove door buckets by pushing bucket up and
pulling out.
• Replace door buckets by sliding bucket in between
shelf rails and pushing door bucket down into place.
9