Installation Instructions

NOTE: If the unit will be controlled by a wireless thermostat

(Goodman DS01E using DT01A antenna on the

unit), the board may have to be configured to allow

the wireless thermostat to operate the unit.

Enter Configuration Mode, select feature code

(C1) by pressing the HEAT button and

option

(rE) by pressing the down arrow.

NOTE: If the unit is being controlled by a wired wall thermo-

stat, the board will have to be configured to allow the

thermostat to operate the unit. To configure for a

wired wall thermostat,

Enter Configuration Mode, select Feature Code

(C1) by pressing the heat button and option (L5)

by pressing the (down)

arrow.

TO SET THE PTAC CONTROL FOR A 4-DIGIT ROOM

NUMBER WIRED THERMOSTAT.

To select interface options, enter configuration mode, press

the HEAT

key until (C4) appears, then press

the up

down arrows to select the first two digits of a

four digit room number.

Press HEAT

again until (C5) appears then press

the up

down arrows to select the last two digits.