Technical information

13
Component Testing Procedures
NOTE: For ohm checks unplug harness connector on console and test from wire insertion side.
Normal resistance is approximately 3.0Ω between any 2 pins
(1,22 or 3) on motor connector.
Motor
1
2
3
WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless
testing requires power.
MEMS Sensor Check
Check voltage at PIN #1 and #5 of CN1
Tester Check = DC5V
Check voltage at PIN #1 and #4 of CN1
Tester Check = Approximately 2.5V (2.2V~2.8V)
MEMS Sensor
1
9
1
5
1 3
1
2
1
1
3
4
5
4
1
8
CN3
CN11
CN9
CN8
CN10
CN5
CN6
CN9
CN7