Specifications

Specifi cation Sheet
www.amana-ptac.com
7
4-1/8"
Hydronic Front
3"
Wall
Sleeve
Top of Wall Sleeve
Bottom of Wall Sleeve
Toe Plate
0" - 3.0" Long
10-13/16"
+1/8"
-0"
Basepan
Condenser
Condenser Baffles
Hydronic Air
Inlet
8-1/4"
20-3/16"
2-1/8"
53"
Steam/Water
Coil Position
Hot Water Inlet / Outlet Connections
Steam Inlet / Outlet Connection
Hot Water Inlet / Outlet Connections
Steam Inlet / Outlet Connections
16-3/4"
Outlet Connection
Steam Inlet
Model
Nominal BTUs
230V 208V 265V
Rated Watts All 1,500 1,200 1,500
Full Load Amps
(incl. fan)
7K & 9K 6.9 6.2 6.1
12K & 15K 7.1 6.4 6.3
Min. Ampacity
7K & 9K 8.6 8.6 7.5
12K & 15K 8.8 8.8 7.7
Fuse Size All 15 15 15
DK900D
Condensate Drain Kit
(use with WS900D)
DK9001D
Condensate Drain Kit (use with
WS900B & extra deep wall sleeves)
KL03B Security Key Lock
REK10B Remote Escutcheon Kit (10-pack)
DGK1B Condenser Baffl e Kit
PVK3A 230/208V
PVK4A 265V
PDK3A 230/208V
PDK4A 265V
HTK3A 230/208V
HTK4A 265V
HWK03 Hydronic Water Kit
HVK03 Hydronic Steam Kit
VS2WNCA* 2-way/24V/NC/Steam
VS2WNOA* 2-way/24V/NO/Steam
VW2WNCA* 2-way/24V/NC/End Switch
VW2WNOA* 2-way/24V/NO/End Switch
VW3WNC2B* 3-way/24V/NC/NO/End Switch
CDP302 230/208V
CDP402 265V
FK10A Filters (10-pack) - A Series
FK10B Filters (10-pack) - B Series
CFK10A
Charcoal Filters
(10-pack) - A Series
CFK10B
Charcoal Filters
(10-pack) - B Series
* Poptop Actuator
Condensate Drain Kit
Attaches to the wall sleeve base pan for con trolled in ter nal or
external disposal of condensate.
Security Key Locks (not shown)
In conjunction with the tamper-resistant front, the in stal la tion of
Amana
®
brand se cu ri ty key locks pre vents tam per ing of the
controls used to set tem per a ture, heat ing and cool ing functions.
U.L. ap proved for in sti tu tion al use only.
Remote Escutcheon Kit (not shown)
Optional kit for use with units controlled via a wall ther mo stat.
Replaces knob controls for units op er at ed by wall thermostat.
Condenser Baffle Kit
For use on non-baffled grilles. These deflectors di rect the air in
to ward the cen ter and away from the inlet to pre vent
re cir cu la tion of the hot con dens er air.
Duct Extension Kit
Extends air distribution to an adjoining room. Con sists of a main
duct for the room of or i gin and an ex ten sion duct to reach the
ad join ing room and ter mi nal duct.
Power Vent Kit (not shown)
Installation of Power Vent increases CFM up to ap prox i mate ly 95.
Vent door will automatically close when unit fan is off.
Power Door Kit (not shown)
Vent door will automatically open when unit fan is on.
Hydronic Transformer Relay Kit (not shown)
Add-on kit that allows field conversion of a standard PTC unit to a
hydronic unit.
Hydronic Heat Kit
Add-on kits fit all units allowing the addition of hy dron ic water or
hydronic steam heat to cool ing and heating units. The kits feature
left- or right-hand pip ing. Unit re tains com plete ser vice ac cess
with a kit installed.
Hydronic Valves (not shown)
Water and steam valves are available for use with the HWK03
(water) and HVK03 (steam) heat kits. (See Ar chi tects and
Engineers Manual for specifications.)
Condensate Removal Pump (not shown)
Can be field installed. Assists in removing con den sate de vel oped
by heat pump operation and trans fers it to in door coil to dis si pate
into room while add ing hu mid i ty to the room.
Spare Filters (not shown)
Helps keep dirt and lint out of the air and off the coil, thus
increasing the unit's efficiency. Amana® brand filters are easy to
remove, wash and replace.
NEW! Replacement Charcoal Filter Kit (not shown)
Absorbs airborne odors caused by cigarette, pipe or cigar smoke
and odors caused by mold, mildew, etc. Filters are made of
polyester fibers coated with activated charcoal and are
individually wrapped. This filters are permanent and can be
washed or cleaned. Call your Amana® brand PTAC sales person
for details. 10 filters per pack.
Heater Kit—For Heater-less Units Only (not shown)
Optional 1.5kW heater kits are avail able for use only with models
orig i nal ly shipped with out elec tric heat. Ask sales per son for details.
Each kit contains 80 wires and wire nuts, enough
to attach a thermostat and one additional
accessory to 10 PTAC units. Wires come in
assorted colors for easy attachement.
Unit Controls
Compartment
Hydronic Air
Discharge
5-1/2"
PTAC UNIT WALL SLEEVE
3-1/4"
1-7/8"
3-1/4"
1-7/8"
2-3/4"
2 places
15/32"
2 places
Hydronic Heat Kit-Top View
Hydronic Heat Kit-Right View
Hydronic Heat Kit-Side View
TRANSITION BAFFLES
Terminal Duct Kit
Extension Duct Kit
Main Duct Kit
DK900D
MDK02B Main Duct
EDK02B Extension Duct
TDK02 Terminal Duct
PTDK01A Transition Duct Only