Product specifications

8 www.amana-ptac.com SS-PTAC50
SPECIFICATION SHEET
PTAC ACCESSORIES (CONT.)
STC 30-RATING ACCESSORY KIT (NOT SHOWN)
Raises sound ratings from 27 to 30 to meet or exceed most sound test requirements.
STC101A 10 Pack
HEATER KIT—FOR HEATER-LESS UNITS ONLY (NOT SHOWN)
Optional 1.5 kW heater kits are avail able for use only with models
orig i nal ly shipped with out elec tric heat. Ask sales per son for
details.
Model Nominal BTUs 230V 208V 265V
Rated Watts All 1,500 1,200 1,500
Full Load Amps
(incl. fan)
7K & 9K 6.9 6.2 6.1
12K & 15K 7.1 6.4 6.3
Min. Ampacity
7K & 9K 8.6 8.6 7.5
12K & 15K 8.8 8.8 7.7
Fuse Size All 15 15 15
SUB-BASE EXTENSION COVER KIT
Converts older 30-amp sub-bases to allow for installation of the larger 30-amp LCDI power cord
and plugs.
SBEC10A 10 Pack
CONDENSATE REMOVAL PUMP (NOT SHOWN)
Can be fi eld-installed. Assists in removing con den sate de vel oped by heat pump operation and
trans fers it to in door coil to dis si pate into room while add ing hu mid i ty to the room.
CDP302 230/208V
CDP402 265V
SECURITY KEY LOCKS (NOT SHOWN)
In conjunction with the tamper-resistant front, the in stal la tion of Amana
®
brand se cu ri ty key locks
pre vents tam per ing of the controls used to set tem per a ture, heat ing and cool ing functions. UL
ap proved for in sti tu tion al use only.
KL03B Security Key Lock
REPLACEMENT SPARE FILTERS (NOT SHOWN)
Helps keep dirt and lint out of the air and off the coil, thus increasing the unit's efficiency. Amana
®
brand filters are easy to remove, wash, and replace.
FK10A Filters (10-pack) - A Series
FK10B Filters (10-pack) - B Series
REPLACEMENT CHARCOAL FILTER KIT (NOT SHOWN)
Absorbs airborne odors caused by cigarette, pipe, or cigar smoke and odors caused by mold,
mildew, etc. Filters are made of polyester fibers coated with activated charcoal and are individually
wrapped. These permanent filters can be washed or cleaned and reused. Call your Amana
®
brand
PTAC salesperson for details.
CFK10A
Charcoal Filters - A Series
(10-pack)
CFK10B
Charcoal Filters - B Series
(10-pack)
HYDRONIC HEAT KIT
Add-on kits fi t all units allowing the addition of hy dron ic water or hydronic steam heat to cool ing
and heating units. The kits feature left- or right-hand pip ing. Unit re tains com plete ser vice ac cess
with a kit installed. Unit must be connected to and operated by a wall thermostat.
HWK03 Hydronic Water Kit
HVK03 Hydronic Steam Kit
Unit Controls
Compartment
Hydronic Air
Discharge
5- 1/ 2"
PTAC UNIT WALL SLEEVE
3-1/4"
1-7/8"
3-1/4"
1-7/8"
2-3/4"
2 places
15/32"
2 places
Hydronic Heat Kit-Top View
4-1/8"
Hydronic Front
3"
W
a
ll
S
le
e
v
e
Top of Wall Sleeve
Bottom of Wall Sleeve
Toe Plate
0" - 3.0" Long
10-13/16"
+1/8"
-0"
Hydronic Heat Kit-Side View
Hydronic Air
Inlet
8-1/4"
20-3/16"
2-1/8"
53"
Steam/Water
Coil Position
Hot Water Inlet / Outlet Connections
Steam Inlet / Outlet Connection
Hot Water Inlet / Outlet Connections
Steam Inlet / Outlet Connections
16-3/4"
Outlet Connection
Steam Inlet
Hydronic Heat Kit-Right View
HYDRONIC VALVES (NOT SHOWN)
Water and steam valves are available for use with the HWK03
(water) and HVK03 (steam) heat kits. (See Ar chi tects and Engineers
Manual for specifi cations.)
VS2WNCA* Two-Way / 24-V / NC / Steam
VS2WNOA* Two-Way / 24-V / NO / Steam
VW2WNCA* Two-Way / 24-V / NC / End Switch
VW2WNOA* Two-Way / 24-V / NO / End Switch
VW3WNC2B*
Three-Way / 24-V / NC / NO / End
Switch
* Pop-top Actuator
HYDRONIC TRANSFORMER RELAY KIT (NOT SHOWN)
Add-on kit that allows fi eld conversion of a standard PTC unit to a hydronic unit.
HTK3A 230/208V
HTK4A 265V