Specifications

61
DISASSEMBLY
7. Remove screws on mid partition panel and shift out of the
way.
8. Remove the two screws securing the heater assembly to
the evaporator.
9. Pull heater assembly up and out of the chassis.
10. Disconnect all wiring to the heater assembly and remove
the assembly.
11. Remove the floodback protector or thermistor from the
evaporator discharge tube.
12. Remove screws holding evaporator to basepan and parti-
tion panel.
13. After recapturing the refrigerant charge (see Refrigeration
Service section), debraze the tubes into the evaporator.
Be sure to protect all chassis components, especially foam
parts, from excessive heat.
14. Lift the evaporator up over the basepan edge and remove.
OUTDOOR COIL
1. Remove the chassis from the wall sleeve.
2. After capturing the refrigerant from the system, debraze
the inlet and discharge tubing from the outdoor coil.
3. Remove all screws from the sides of the outdoor coil se-
curing the shroud to the coil.
4. Pressing the tabs on the right side of the shroud separate
the shroud from the outdoor coil.
5. The "E-K" models have a four piece condenser shroud where
the top, sides and schroud will come apart separately.
5. Remove the two screw securing the outdoor coil to the
base pan.
6. Carefully lift the outdoor coil over the basepan lip.
VENT DOOR
1. Remove Chassis from wall sleeve.
2. Remove P clamp securing vent door control cable to cen-
ter partition and disconnect cable from vent door.
3. Remove vent door by opening door and pulling hinge tabs
out of slots in center partition.
4. Remove the door by pulling hinge tabs out away from the
center partition.