Specifications

31
8. Press HEAT key to scroll to third unoccupied
setback temperature. Press either the up or down arrow
to the desired third unoccupied setback tempera-
ture.
9. Press HEAT
key to scroll to third unoccupied
setback time. Press either the up or down arrow to
the desired third unoccupied setback time.
10.. To exit configuration mode:
Press the OFF key. NOTE: Configuration feature
mode will also automatically exit if no keys are
pressed for a period of two (2) minutes.
The changes made in configuration mode are now in effect.
NOTE: Additional codes are present and may be accessed
within this menu. Contact the manufacturer for additional infor-
mation.
TYPICAL ROOM LAYOUTS
PTAC
OUTSIDE
PTAC
OUTSIDE
CAUTION
THIS EQUIPMENT IS AUTHORIZED FOR USE UNDER THE UNITED
STATES FEDERAL COMMUNICATION COMMISSION RULES AND
REGULATIONS, CODE OF FEDERAL REGULATIONS CHAPTER 47
PART 15 AND MUST BE INSTALLED IN ACCORDANCE WITH THE
INSTRUCTIONS PROVIDED IN THIS DOCUMENT. FAILURE TO
INSTALL OR OPERATE THIS EQUIPMENT AS INSTRUCTED IN THIS
DOCUMENT COULD VOID THE USER’S AUTHORITY TO OPERATE THE
EQUIPMENT. THIS EQUIPMENT CONTAINS NO USER SERVICEABLE
PARTS. ANY MODIFICATION OR REPAIRS TO THE INTERNAL
COMPONENTS OR TO THE ANTENNA CONFIGURATION OF THE
NOTE: To comply with FCC RF exposure requirements in section 1.1307, a
minimum separation distance of 20cm (8 inches) is required between the
equipment and all persons.
NOTE: TH IS EQUIPMEN T HAS BEEN TE STED AND FO UND TO COMPLY
WITH THE LIMITS FOR A CLASS B DIGITAL DEVICE, PURSUANT TO
PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO
PROVIDE REASONABLE PROTECTION AGAINST HARMFUL
INTERFERENCE IN A RESIDENTIAL INSTALLATION. THIS EQUIPMENT
GENERATES, USES AND CAN RADIATE RADIO FREQUENCY ENERGY
AND, IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE
INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO RADIO
COMMUNICATIONS. HOWEVER, THERE IS NO GUARANTEE THAT
INTERFERENCE WILL OCCUR IN A PARTICULAR INSTALLATION. IF
THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO RADIO
OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY
TURNING THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED
TO TRY TO CORRECT THE INTERFERENCE BY ON OR MORE OF THE
FOLLOWING MEASURES:
REORIENT OR RELOCATE THE RECEIVING ANTENNA.
INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND
RECEIVER.
CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT
DIFFERENT FROM THAT TO WHICH THE RECEIVER IS
CONNECTED.
CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV
TECHNICIAN FOR HELP.
-
-
-
-
PROPER INSTALLATION