Specifications
CT-DPTAC www.amana-ptac.com 7
accessories (conT.)
Used to permanently wire to the chassis when a standard sub-base
and power cord are not ulized.
PTPWHWK4 Armored Cable -
all voltages
PTQCO3A Quick Connect -
230/208V
PTQC04A Quick Connect -
265 & 115 V
The PSHW**A power disconnect switch can be used for 265-volt or
230/208-volt physical disconnect, where required by local codes.
The switch is rated at 30-amp capacity. The switch is for use with and
Amana® brand standard sub-bases or PTPWHWK4 Hard Wire Kit.
PSHW03A 230/208V
PSHW04A 265V
Cartridge-style fuses can be installed in the fuse holder for use in the
sub-base or chassis. Available in 15, 20 and 30 amp (included on 265-
volt unit).
FHK315C 230/208V 15A
FHK315E 230/208V 15A (R-410A)
FHK320C 230/208V 20A
FHK320E 230/208V 20A (R-410A)
FHK330C 230/208V 30A
FHK330E 230/208V 30A (R-410A)
The circuit breaker kit, available in 15, 20 or 30 amp, can be used
with Amana brand sub-bases. It gives overcurrent protecon, and its
locaon allows you to turn the unit on or o without tools.
CBK3**C Circuit Breaker Kit
Extends air distribuon to an adjoining room. Consists of a main duct for
the room of origin and an extension duct to reach the adjoining room
and terminal duct. PTDK01A allows for the new “B” series unit to work
with the “A” series duct kits.
MDK02B Main Duct – R-22
MDK01E Main Duct – R-410A
EDK02B Extension Duct
TRANSITION BAFFLES
Main Duct Kit
TDK02 Terminal Duct
PTDK01A Transion Duct Only – R-22
PTDK01E Transion Duct Only –
R-410A
Extension Duct Kit
Terminal Duct Kit
Installaon of Power Vent increases CFM up to approximately 95. Vent
door will automacally close when unit fan is o.
R-410A models must have these kits installed at the factory.
PVK3A 230/208V – R-22
PVK4A 265V – R-22
PVK3E 230/208V – R-410A
PVK4E 265V – R-410A
For use on non-baed grilles. These deectors direct the air in toward
the center and away from the inlet to prevent recirculaon of the hot
condenser air.
DGK1B Condenser Bae Kit
Basepan
Condenser
Condenser Baffles