IC7 Bottom Freezer Refrigerator Ice Maker Kit Installation and Operating Instructions
Contents Safety Instructions Introduction ............................................................... 3 WARNING Safety Instructions .................................................... Materials Required .................................................. Parts ....................................................................... Procedure ...............................................................
Parts Use listed part numbers only when ordering replacement parts. Part numbers are not used in installation instructions.
16 15 \ 3 4 \ 6 ! 11 14 _12
Procedure 7. Connect wires to water valve. Place water valve on 1. Turn off water supply to refrigerator. mounting bracket. Insert screws into top 2 holes in water valve cover plate and lower 2 holes in mounting bracket. Tighten screws with a 1/4" hex nut driver. Caution To avoid property damage, protect soft vinyl or other flooring with cardboard, rugs, or other protective material when moving refrigerator. 8. Replace fiberboard back cover by placing cover on refrigerator cabinet.
12.Removeiceservicerackby liftingrackoffplastic washersthenpullingout.Removescrewswitha 1/4"hexnutdriver.Insertplugsintoscrewholes. 17. Remove water tube inlet hole plug on rear of refrigerator cabinet with a screwdriver covered with masking tape. / f Washer \ } 1/4" (6 mm) 13. Locate electrical and water connection cover plate on upper left rear wall of freezer. Remove electrical and water connection cover plate by removing screw with a 1/4" hex nut driver.
21. Slidestainlesssteelclipoverwallof icemaker watercup. Stainless steel clip 22. Remove 3 button plugs from left freezer wall with a knife covered with masking tape. Discard plugs. 23. Start 5/8" (15 mm) sheet metal screw in top front hole on left wall with a 1/4" hex nut driver. Leave head out approximately 3/8" (9 mm). 24. Hold ice maker in position. Ice maker can only be installed one way. Do not drill additional holes.
Operating Instructions Before Calling For Service Confirm ice bucket is in place and ice maker arm is down. ..... === . Give ice maker 1 overnight period to make ice before assuming a difficulty exists. If ice maker is not producing ice • Confirm ice maker arm is down. Ice bucket and :............................ I I ' i "- ..... ' Lo ;ked position X,IX Up position slide out shelf must be in proper position for ice maker to produce ice.
Warranty Ice Maker Full One Year Warranty First Year Amana Refrigeration, Inc. will repair or replace, free of charge, any part which is defective due to workmanship or materials. Warranty Limitations • Begins at date of original purchase. • Applies to product used within the United States or in Canada if product has Canadian Standards Association listing when shipped from the factory. • Service must be performed by an authorized Amana ®technician.
Part No. 10527010 Printed in U.S.A. sna A Ra_/l'h_.NmCompany _h1996 Amana Refrigeration, Inc.
