Instructions

1. Open oven door and place food in oven. Close door.
2. Press TIME ENTRY pad and enter cooking time.
3. Press POWER LEVEL pad to change power level if desired.
• For a lower microwave power, press pads 1 (for 10%) through 9 (for
90%)
• Press same number keypad again to change power level to 100%
4. If stage cooking is desired, press STAGE pad and repeat steps 2 through
4.
5. Press START pad.
6. At end of cooking cycle oven beeps and shuts off. DONE displays.
intervals. When the message displays, ACP recommends
will not shut off the message. The message will stop
displaying automatically after 24 hours. Depending on
may need to be cleaned more frequently.
To cook food using preprogrammed cooking sequences.
1. Open oven door and place food in oven. Close door.
• To add an additional serving press QUANTITY pad.
• Display will read, “DOUBLE.”
2. Press desired pad.
3. Oven begins to cook.
4. At end of cooking cycle oven beeps and shuts off.
DONE displays.
A—For North American (UL/CSA) models, allow at
least 2” (5.1 cm) of clearance around top of oven.
For International (50 Hz) models, allow at least 7”
(17.8 cm) of clearance around top of oven. Proper
properly and life of electrical parts is reduced.
B—Allow at least 2
9
/16” (6.5 cm) between air
discharge on back of oven and back wall.
C—Allow at least 2” (5.1 cm) around sides of oven.
Refer to Product Safety Manual for Safety Statements
Complete Owner’s Manual available online
Quick Start Reference Guide
Quantity
Time Entry
Power Level
Stage
Program Save
This guide covers model: AMSO*
1
2
3
4
A/B
0
X2
A/B Pad
User can program up to four different
stages per keypad to combine power levels
and time changes.
Changes microwave power level for
different stages of a cook cycle.
Automatically adjusts preprogrammed cook
cycle for cooking two of the same food
item.
Cooking time can be changed for either
manual entry or programming.
Programs or settings can be changed and
saved based on a user’s preference.
Toggles selection between two sets of
preprogrammed menu settings.
Oven Clearances
Preprogrammed Pads
1. Oven must be in READY mode. If not, open and close the
door.
2. Open the oven door completely.
3.
4. Press and hold the 5 keypad until “USB” appears on the
display.
5. To transfer FROM
TO the oven, press the
1 pad.
• Or to transfer programs TO
FROM the
oven, press the 2 pad.
6. Push the START pad to begin transfer.
• Display will read, “Contacting USB card.”
• Display will then read, “Transferring data from USB to oven,”
or vice versa
7. Once programming has been successfully transfered, display
will read, “Done - Loaded __ Programs.”
• Shut the door to clear the display and begin a cooking cycle.
USB Compatibility
 2014 ACP, Inc.
225 49th Avenue Drive
Cedar Rapids, Iowa 52404
For full product documentation visit:
www.acpsolutions.com
the microwave oven, allowing the user to save
oven.
CLEAN FILTER
Manual Operation