Use & care guide

12
Turn the Gas Supply On
For outdoor grills using a 20 lb. LP gas fuel tank: Slowly 1.
open the tank valve.
NOTE: If ow limiting device activates, your grill may not
light. If your grill does not light, the ames will be low and will
not heat properly. Turn tank valve and all control knobs off
and wait 30 seconds. After shutting off the tank, very slowly
open tank valve and wait 5 seconds before lighting.
Lighting the Grill
1. Do not lean over the grill.
Push in and turn any grill burner control knob to HIGH, and 2.
immediately press the electronic igniter button.
You will hear the “snapping” sound of the spark igniter. When 3.
burner is lit, release the knob. Turn knob to desired setting
Repeat steps 2 and 3 to light the other burners.4.
IMPORTANT: If burner does not light immediately, turn the
burner knob to OFF and wait 5 minutes before relighting.
Manually Lighting the Grill
1. Do not lean over the grill.
Remove the manual lighting extension and attach a match to 2.
the split ring.
Strike the match to light it.3.
Guide the lit match between the grill grate and one of the slots 4.
in the avor grid near the burner to be lit.
5. Push in and turn the burner knob to HIGH. The burner will
light immediately. When burner is lit, turn knob to desired
setting.
6. Repeat steps 3 through 5 to light the other burners.
Remove match and replace manual lighting extension.7.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting to light them manually,
contact customer service. See the “Assistance” section.
Check the Burners
Burn Hazard
Do not let the burner ame extend beyond the edge
of the pan.
Doing so can result in burns
Lighting the Side Burner
Open the side burner cover. Do not light burners with the 1.
cover on.
Do not lean over the grill.2.
Push in and turn the control knob to HIGH and immediately 3.
press the electronic igniter button.
You will hear the “snapping sound of the spark igniter. When 4.
burner is lit, release the knob. Turn knob to desired setting.
IMPORTANT: If burner does not light immediately, turn the
burner knob to OFF and wait 5 minutes before relighting.