Use and Care Manual

10
Installation Instructions
INSTALL THE CASE
IN THE WINDOW
(cont.)
Adjust the leveling bolts and nuts against the
outside wall so that the case has a slight tilt
to the outs ide. Tighten nuts with an adjustable
wrench. Use a level; about a 1/2 bubble will
be the correct case slant to the outside.
Use a w ood block (obtained locally) between
the leveling bolts and the wall if the wall is
weak or if the weight of the air conditioner
falls between the studs in the wall.
E xtend the left and right accordion panels
to the vertical window sashes. Drill pilot
holes and attach the top and bottom corners
with 4 type D screws.
F
E
D
6
Type D
screw
Type D
screw
Type D
screw
Top mounting rail
Type D
screw
INSTALL SUPPORT BRACKETS
AND THE FOAM TOP WINDOW
GAS K E T
Attach the s upport brackets with two
type D screws , one on each side.
Cut the foam top window gasket to the
window width.
Stuff the foam between the glass and the
window to prevent air and ins ects from
getting into the room .
C
B
A
7
Adjust the leveling bolts and nuts against the
outside wall so that the case has a slight tilt
to the outside. Tighten nuts with an adjustable
wrench. Use a level; about a 1/2 bubble will
be the correct case slant to the outside.
Installation Instructions