Dimensions

Because Whirlpool Corporation includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10403811C
05/20/2016
30" (76.2 cm) Freestanding Electric Range
PRODUCT MODEL NUMBERS
ACR2303MF
ACR3130BA
ACR4303ME
ACR4303MF
ACR4503SF
ACR4530BA
ACR4503SF
AER3311WA
AER5330BA
AER5523XA
AER5524XA
AER5630BA
AER5823XA
AER5830VA
AER6303MF
AER6603SF
Electrical: To properly install your range, you must determine the type
of electrical connection you will be using and follow the instructions
provided for it here.
■ Range must be connected to the proper electrical voltage and
frequency as specified on the model/serial number rating plate. The
model/serial number rating plate is located on the left-side frame
behind the storage drawer panel or behind the top right side of the
oven door. Refer to the figures in the “Product Dimensions” section of
the “Location Requirements” section.
■ This range is manufactured with the neutral terminal connected to
the cabinet. Use a 3-wire, UL Listed. 40- or 50-amp power supply
cord (pigtail) (see following Range Rating chart). If local codes do not
permit ground through the neutral, use a 4-wire power supply cord
rated at 250 volts, 40 or 50 amps and investigated for use with ranges.
Range Rating*
Specified Rating
of Power Supply
Cord Kit and
Circuit Protection
120/240 Volts 120/208 Volts Amps
8.8 – 16.5 KW 7.8 – 12.5 KW 40 or 50 **
16.6 – 22.5 KW 12.6 – 18.5 KW 50
* The NEC calculated load is less than the total connected load listed on
the model/serial rating plate.
** If connecting to a 50-amp circuit, use a 50-amp rated cord with a kit.
For 50-amp rated cord kits, use kits that specify use with a nominal
1
3
/
8
" (34.9 mm) diameter connection opening.
■ A circuit breaker is recommended.
PRODUCT DIMENSIONS
A
B
C
D
E
F
A. 27
3
/
4
" (70.5 cm) max. depth with handle
B. 46
7
/
8
" (119.1 cm) overall height (max.) with leveling legs
screwed all the way in*
C. 36" (91.4 cm) cooktop height (max.) with leveling legs screwed
all the way in*
D. 29
7
/
8
" (75.9 cm) width
E. 25
5
/
16
" (64.3 cm) depth – back of range to front of cooktop**
F. Model/serial rating plate (located on the left-side frame behind
storage drawer or right side of frame behind the oven door)
IMPORTANT: Range must be level after installation. Follow the
instructions in the “Level Range” section. Using the cooktop as a
reference for leveling the range is not recommended.
* Range can be raised approximately 1" (2.5 cm) by adjusting the
leveling legs.
** Front of door and drawer may extend further forward depending on
styling.
Cabinet opening dimensions shown are for 25" (64.0 cm) countertop
depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop
height.
IMPORTANT: If installing a range hood or microwave hood combination
above the range, following the range hood or microwave hoods
combination instructions for dimensional clearances above the cooktop
surface.
A freestanding range may be installed next to combustible walls with
zero clearance.
* NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet
is covered by not less than
1
/
4
" (0.64 cm) flame retardant millboard
covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm)
stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
CABINET OPENING DIMENSIONS
A
B
D
F
E
C
A. 13" (33.0 cm) max.
upper cabinet depth
B. 30" (76.2 cm) min.
opening width
C. For minimum clearance
to top of cooktop, see
NOTE*
D. 30
1
/
8
" (76.5 cm) min
opening width
E. Outlet – 8" (20.3 cm)
to 22" (55.9 cm)
from either cabinet,
5
1
/
2
" (14.0 cm) max. to
floor
F. Cabinet door or hinges
should not extend into
the cutout