Installation Manual

7
3A-1
3A-2
Position the wall plate at your
desired height and line up the
holes with your stud center line.
Level the wall plate and mark
the holes.
Use a stud finder (not included)
to locate wood studs or use an
awl (not included) to verify the
edges. Mark the edge and
center locations.
24in. (610mm)
16in. (406mm)
awl
(not included)
Wall
Anchor
O
X
01
02
Step 3A Wood Stud Option
WARNING:
Ensure the wall plate is securely fastened to the wall before
continuing to the next step.
● Any material covering the wall must not exceed 5/8 in. (16 mm)
● Nominal wood stud size: common 2 x 4 in. (51 x 102 mm)
minimum 1.5 x 3.5 in. (38 x 89 mm)
● Stud center must be verified
Avoid potential personal injury or property damage! DO NOT over-tighten
the lag screws [G]. Tighten the lag screws [G] only until the washers [H]
are pulled firmly against the wall plate [01 and 02].
DO NOT USE ANCHOR FOR THIS STEP