User Manual

15
Mounting the wall bracket
Required tools
Drill; 6 mm masonry/concrete drill bit; Phillips head screwdriver
Caution
Ensure that there are no electric lines, water or heating pipes installed
at the proposed drilling location.
The supplied wall plugs are only suitable for mounting on concrete and
stone. Before starting the installation, please check your installation
location carefully for its suitability for the plugs.
The assembly material used must be suitable for the respective
location. If in doubt, consult a professional.
Install Steps
Mark the drill holes by holding the foot of the wall bracket at the desired
mounting location and marking the hole positions.
Use a drill with a 6 mm drill bit to drill the required holes and insert the
plugs and insert the wall plugs flush with the wall.
Screw the wall bracket to the wall using the supplied screws.
Mount the camera on the tripod screw and screw the camera a little
way on (about three turns).
Turn the camera in the desired direction and lock it with the lock nut.
To move the camera into its final position, undo the two pivot bolts a
little, position the camera and fix the position by tightening the two
pivot bolts.