User Manual

12
Fuse
Battery
Air outlet
Air inlet
Air inlet hole
Air outlet hole
Seal gasket
Fixed plate
M6 flat washer,
nut
Fixed hose
clamp
Fixed clamp
Pay attention to high temperature
Butt plugs of
main wire
harness and
switch
Mechanical
switch
Fuel pump wire
harness connector
Pulse fuel pump
Pump damping
rubber
Filter
Fuel Supply
Pipe
Fuel tank
Fill-35 Diesel
This screw fixes
the fuel tank to
the sheet metal
of the car body
Air inlet
pipe
Exhaust pipe
(Combustion
gas)
Special Attention:
The parking heater must be installed vertically
Do not lean or lie flat (as shown in the picture)
In order to ensure that the air intake is smooth
and the heater is working properly the gap at the
front of the air inlet shall not be less than 10 cm.
The fuel pump must be installed verticallyor at an
angle of 45 degrees with the oil outlet end
upward (as shown in the picture)
The air inlet and
outlet port must
not be in the same
direction.
After the installation, please check the entire line
to ensure that the oil path is unobstructed, no oil
leakage, and the circuit connection is good,
otherwise it will affect the normal operation of
the heater.