Installation & Assembly (Full)

Page 3 of 3
FULL/QUEEN BED FRAME
STEP 4:
Insert 2 pieces of Side Plastic Cover (E) into each end of 2 pieces of Slats (7)
as shown.
Insert the other end of the Slats (7) into 1 piece of Center Plastic Covers
(J)
as shown.
Insert the assembled Side Plastic Covers (E) into the corresponding holes on Long Board (2), and insert the assembled Center
Plastic Cover (J) into the corresponding holes on Center Rail (5)as shown.
Repeat the same steps for the remaining 22 pieces Slats (7).
Ex24
Hardware & Tool required
1
7
4
E
E
2
1
2
H
x2 Bx1 Fx1 Gx1Dx1
STEP 3:
Place Stretcher (4) to the
as sembled Long Board (2) and Center Rail (5)
as shown.
Secure the end
of
Stretcher (4) by using 2 pieces of Bolts (H) as shown.
Secure the middle of Stretche
r (4)
by using 1 piece of Bolt (G)
and Flat Washer (K).
Tighten Bolts (G) by using Allen Wrench (F ) and Nut (B).
Hardware & Tool required
2
4
2
2
1
4
G
F
1
5
6
6
1
5
4
H
F
7
5
J
Assembly is complete. Your bed frame is ready to be enjoyed now!
Jx12
D
B
K
Kx
1
6
6
middle holes of
Dot not fully tighten Bolts (G) a
t this step.
Please fully tighten all Bolts(A)(G)(H)(I).