User manual

Always “On” UPS Systems Inc.

13 Version 2.2

7. BATTERY REPLACEMENT

Your battery should run anywhere from 3-5 years before it needs to be replaced.

Please follow the instructions below for easy, trouble free, battery replacement.

1. Turn the UPS off (follow procedure previously mentioned).

2. Unplug the UPS from utility power source and disconnect all connected loads.

3. Disconnect AC power cord from unit.

4. For the 801V / 102V / 152V / 222V: Pull on the top of the faceplate until the 2

top tabs release. Remove the faceplate and set to the side.

For the 152 / 222VR: Using a Phillips screwdriver, remove the 2 screws

holding the faceplate on. Remove the faceplate and set to the side.

For the 102VR: Turn the UPS upside down. Using a Phillips screwdriver

remove the 4 screws holding the top to the bottom. Flip the UPS right side

up. Remove the 8 screws for the handles and the one screw on the back.

5. For the 801V / 102V / 152V / 222V: The battery retainer plate should be

visible. Using a Phillips screwdriver remove the screw at the battery plate

and set the plate to the side.

For the 152 / 222VR: The battery retainer plate should be visible. Using a

Phillips screwdriver remove the 3 screws holding the battery retainer plate

on and set the plate to the side.

For the 102VR: From the back pull the top cover off of the UPS.

6. For the 801V / 102V / 152V / 222V: Carefully pull the batteries out of the UPS.

Remove the connecting wires noting polarity.

For the 152 / 222VR: Carefully pull the batteries out of the UPS using the

white tab hanging in front of the batteries. Remove the connecting wires

noting polarity.

For the 102VR: Remove the connecting wires from the batteries noting

polarity.

7. You can now easily remove the battery from the unit

8. Place your new battery in the same position, direction and reconnect the wires.

The red wire to the positive (+) pole and black wire to the negative (-) pole.

9. Reverse the above steps to reassemble the unit.

10. Follow start-up instructions in order to properly reconnect your equipment.

Caution:

Do not dispose of battery in a fire. Do not attempt to open the battery.

When replacing the battery use tools with insulated handles and

remove watches, rings, etc…

WARNING:

Completing the procedure below will void any remaining warranty on

the UPS s

stem.