Product Manual

Step 4

Bolt Tightening Sequence

Tighten all (22) 2¼" bolts using the following sequence. We

recommend a gradual tightening process in which you go

through the sequence a few times and tighten the bolts more

each time. This will ensure good joint alignment. Pay special

attention that the legs align well with the tabletop assembly.

Footrest to side rails ﬁrst.

Side rails to legs second.

Back rail to legs third.

Legs to tabletop assembly fourth.

Step 5

Without cutting plastic wrap yet, lift from under the

tabletop (not the legs) and carefully ﬂip table into the

upright position. This will require two people. Use care to

prevent scratches or other damage.

Cut plastic wrap.

Pencil ledge (

) has two functions, depending on which

edge faces up. The raised position prevents materials from

sliding off the tilted surface. The ﬂush position provides a

comfortable, rounded edge for your forearms.

Choose which position you desire and attach pencil ledge

to front edge of tabletop using 1/2" bolts (

) into threaded

inserts, as shown in Figure 5. Tighten ﬁrmly using care not

to strip.

Step 6

Lift back of tabletop into an elevated tilt position to

gain access to back of drawer. (See directions for

adjusting tilt on the last page of these instructions.)

Insert drawer dividers (

) into desired slots as

shown in Figure 6.

Figure 4

Figure 5

Figure 6

1st

2nd

4th

3rd