Product Manual

2
Step 2
Side rails (
5 &6
) have angled ends and off-center middle
holes. They are not interchangeable.
The face of each side rail with seven holes should face in.
The middle three holes should be closest to the back of the
table (furthest from drawer knob).
Double-check that angled ends align properly with legs
before bolting.
Connect side rails between legs using 2¼" bolts and barrel
nuts (
B
) as shown in Figure 2. Keep all bolts slightly loose
to allow for assembly steps to follow.
1
2
3
4
5
Step 1
Remove parts from carton and check that all are
present. For ease of handling and assembly, do not cut
plastic wrap around tabletop assembly (
9
) until the
end of the assembly process.
Use care in handling all parts to prevent scratches
and other damage. Two people will be necessary to lift
tabletop assembly from carton.
Place tabletop assembly on a carpeted or otherwise
protected floor with the drawer unit facing up, as
shown in Figure 1.
Each leg is numbered (
1- 4
) and must be attached to
the corner with corresponding number.
Insert two dowels (
D
) in each leg (no glue necessary)
and attach legs to tabletop assembly using 2¼" bolts
(
A
) and washers (
E
). Keep all leg bolts slightly loose
to allow for assembly steps to follow.
1
2
3
4
5
©2012 ALVIN & COMPANY, INC.
Figure 2
Figure 3
7
8
D
B
A
5
6
A
B
Figure 1
3
4
9
E
A
2
1
D
Step 3
1
2
3
4
5
Back rail (
7
) has angled ends. Double-check
alignment with legs before bolting in place.
Insert 2 dowels into each end of back rail
(no glue necessary).
Connect back rail between legs using 2¼" bolts
and barrel nuts as shown in Figure 3. Keep bolts
slightly loose.
Insert 1 dowel into each end of footrest (
8
)
(no glue necessary).
Connect footrest between legs using 2¼" bolts and
barrel nuts. Rounded edge should face tabletop. Keep
bolts slightly loose.