Product Manual

ManualsBrandsAlvin ManualsDrafting TablesVanguard Drawing Room Table

Vanguard

™

Drawing Room Table

Tools required: Phillips screwdriver, slotted screwdriver.

Assembly Instructions

For VAN42

VAN48

Important notes:

1. Power tools for assembly are not recommended. Great care must be taken to avoid

over-tightening screws so that holes are not stripped accidentally.

2. Wood products can be easily scratched if not handled carefully. Please use care

when unpacking and assembling to prevent damage.

Barrel Nuts

14 pcs

Allen Wrench

1 pc

Wood Dowels

14 pcs

Bolts, 2¼"

22 pcs

Wood Plugs

10 pcs

Bolts, 1/2"

4 pcs

Washers

8 pcs

Tabletop Assembly

1 pc

Leg - Back Left

1 pc

Leg - Front Left

1 pc

Leg - Back Right

1 pc

Leg - Front Right

1 pc

Side Rail - Left

1 pc

Side Rail - Right

1 pc

Back Rail

1 pc

Footrest

1 pc

Pencil Ledge

1 pc

Drawer Dividers

2 pcs

How To Install Bolts and Barrel Nuts

Insert barrel nut (

) in predrilled hole of side

rails (

5 &6

Use screwdriver to ensure long slot is aligned

with bolt (

A &G

Insert bolt and tighten.

Long slot in barrel nut must align with bolt.

Summary of content (4 pages)

PAGE 1
Vanguard ™ Drawing Room Table Assembly Instructions Tools required: Important notes: 1 Phillips screwdriver, slotted screwdriver. 1. Power tools for assembly are not recommended. Great care must be taken to avoid over-tightening screws so that holes are not stripped accidentally. 2. Wood products can be easily scratched if not handled carefully. Please use care when unpacking and assembling to prevent damage.
PAGE 2
Step 1 1 Remove parts from carton and check that all are present. For ease of handling and assembly, do not cut plastic wrap around tabletop assembly (9) until the end of the assembly process. 2 Use care in handling all parts to prevent scratches and other damage. Two people will be necessary to lift tabletop assembly from carton. 3 Place tabletop assembly on a carpeted or otherwise protected floor with the drawer unit facing up, as shown in Figure 1.
PAGE 3
2nd Step 4 Bolt Tightening Sequence 2nd Tighten all (22) 2¼" bolts using the following sequence. We recommend a gradual tightening process in which you go through the sequence a few times and tighten the bolts more each time. This will ensure good joint alignment. Pay special attention that the legs align well with the tabletop assembly. 1 Footrest to side rails first. 2 Side rails to legs second. 3 Back rail to legs third. 4 Legs to tabletop assembly fourth.
PAGE 4
Step 7 1 Now that your table assembly is nearly complete, we recommend that you go back and tighten all the leg bolts and screws one more time. This will ensure that your table remains strong, sturdy, and stable for years of use. 2 Optional Insert the wood plugs (F) into each of the bolt holes as shown in Figure 7. Gently tap into place. Please don’t install with permanent adhesive.