User`s guide

Using the Local Terminal for Unit Setup and Management
BreezeNET PRO.11 Series
3-7
User’s Guide
• Maximum number of Associations since last reset (AP Only) – Maximum
number of stations that were associated with an AP since the last reset.
• Current Number of Authentications (AP Only) – Total number of stations
currently authenticated with an AP. A station may be concurrently
authenticated with several APs, but is associated with only one AP at a time.
• Maximum number of Authentications since last reset (AP Only) –
Maximum number of stations that were authenticated with an AP since the last
reset.
3.4.2 IP and SNMP Parameters
All BreezeNET PRO.11 units contain IP host software. This software can be used
for testing the unit for SNMP management functions and for downloading software
upgrades using the TFTP protocol.
• IP Address – IP address of the unit.
• Subnet Mask – Subnet mask of the unit.
• Default Gateway Address – Gateway address of the unit.
• SNMP Traps – Type 0 to disable SNMP trap sending.
Type 1 to enable SNMP trap sending. When an event occurs, a trap is sent to
the defined host address (see the Appendix for a list of traps). You can
configure the host address to which the traps are sent through SNMP
management.
• Display Current Values – Type A to displays information concerning the
current status of all IP-related items.
3.4.3 Wireless LAN (WLAN) Parameters
The WLAN Parameters menu contains the following options:
• Hopping Sequence (AP Only) – Hopping sequence of the unit. A hopping
sequence is a pre-defined series of channels (frequencies) that are used in a
specific, pseudo-random order as defined in the sequence. The unit “hops” from