User`s guide

Using the Local Terminal for Unit Setup and Management
User’s Guide
3-2
BreezeNET PRO.11 Series
⇒
To use Local Terminal Management:
1. Click an option number to open/activate the option. You may need to press
Enter in some cases.
2. Press Esc to exit a menu or option.
3. Reset the unit after making configuration changes.
3.2 Configuration Screens
Listed below are the menus, sub-menus, and parameters/options in the terminal
program that the Installer can edit. Default values are listed where applicable.
Numbers in the table below indicate how to reach each option. For example, to
reach the 1.2.1 IP Address option, start at the main menu and press 1, then 2, and
then 1.
Menu Sub-Menu Sub-Menu Default Values
1.
System
Configuration
1.1. Station Status
1.2. IP and SNMP
Parameters
1.2.1 IP Address
1.2.2 Subnet Mask
1.2.3 Default Gateway Address
1.2.4 SNMP Traps
1.2.A Display Current Values
Enabled
1.3. Wireless LAN
(WLAN)
Parameters
1.3.1 Hopping Sequence (only for AP)
1.3.2 Hopping Set (only for AP)
1.3.3 ESS ID
1.3.4 Max. Data Rate
1.3.5 Transmit Antenna
1.3.6 Mobility
1.3.7 Load Sharing
1.3.8 Preferred AP (not available for APs)
1.3.A Display Current Values
1
1
ESSID1
3Mbps
Use 2 Antennas*
Low
Disabled**