User`s guide

Appendix
User’s Guide 9-4 BreezeNET PRO.11 Series
Technical Specifications AP-10 PRO. 11, SA-10/40 PRO. 11,
WB-10 PRO. 11
SA-PCR PRO.11
SA-PCD PRO.11
Transmitted power - external antennas D models:
- High Power (at the connector):
17dBm (50mW)
- Low Power (at the connector): 4dBm
(2.5 mW)
DE models:
At the connector: -2dBm (0.01mW)
N/A
DL models:
At the connector: 4dBm (2.5mW)
Sensitivity: @ 1 Mbps
@ 2 Mbps
@ 3 Mbps
−81dBm
−75dBm
−67dBm
Modulation Multilevel GFSK
Demodulation Technology DSP-based with adaptive equalization
Antenna Diversity Two antennas, selected for use on a packet basis
Frequency Accuracy
+
/- 10 PPM
Approvals of Compliance FCC part 15, ETS 300-328, UL, UL/C, TUV/GS, CE
Configuration and Management
Configuration and Setup Via Local Monitor port (serial RS-232) Via Application
SNMP management
SNMP agents
Access via
MIB II, Bridge MIB, WLAN MIB, and private
MIB
Wired LAN, Wireless LAN
N/A
Site Survey Via Local Monitor port (serial RS-232)
Via SNMP
Via Application
Front Panel Display LED
indicators
- Power on
- Wired LAN activity
- Wireless LAN synchronization
- Wireless LAN signal quality/Load
- Link Status
- Data Traffic
S/W upgradeable Through TFTP download via PC
System Considerations
Range (Access Point to Station) Depends on rate and antenna cable length/quality.
(Accurate values must be calculated for specific installations).
Refer to Section 5.3.7.