User`s guide

Upgrade Procedure
BreezeNET PRO.11 Series 7-1 User’s Guide
7. UPGRADE PROCEDURE
Firmware upgrades to the unit's flash memory is done by a simple download
procedure using a TFTP application. Before beginning an upgrade, be sure you
have the correct files and latest instructions. Upgrade packages can be obtained at
the BreezeCOM web site: http://www.breezecom.com/TechSupport/techsupp.html.
In general terms, upgrading includes the following steps:
1. Set up an IP connection to the device. You can verify working connection using
the Ping command.
2. Run TFTP software and connect to the device.
3. Use TFTP to download the Flash erase file to the device. Use the tables below
to determine the specific file to use, according to the unit’s current version.
This causes the flash memory to be cleared.
Do not reset the device during the download procedure in any case.
4. Use TFTP to download the software file to the device. Use the tables below to
determine the specific file to use, according to the unit’s current version.
5. The unit resets itself and comes up with the new upgraded version.
Table 7-1. Upgrade Files
Current Flash Erase
Software Download File Name
Version of Unit File Name
AP-10 SA-10, SA-40,
WB-10
3.2, 3.38, 3.42, 3.50 download eanaf eansf
3.52, 4.204 erase eanafb eansfb
3.62, 4.210, 4.211,
4.310
erase -fw ap_fw sawb_fw
The current version and type of the unit determine the files used for upgrade. For
example, when upgrading an AP-10 from version 3.52 to version 4.4.1, use the
erase and eanafb files. When upgrading a SA-10 from version 3.62 to version 4.4.1,
use the fw-erase and sawb_fw files.