User`s guide

Accessory Installation
BreezeNET PRO.11 Series 6-9 User’s Guide
The DC Power Injector is not in a waterproof enclosure and must be protected from
the weather. It can be permanently mounted to a surface using the mounting
flanges. For more information on amplifier installation, refer to Figure 6-7.
Note: When using the 24dB gain dish antenna in the United States, the external
filter (P/N: SPF-1) must be installed to comply with FCC emission
requirements.
DC POWER
INJECTOR
BreezeNet
Radio
To Ethernet
Hub
UTP Cable
5ft. LMR-400
RF + DC
N-Male to
N-Male adapter
to attach to the
N-Female on
cable
Special SMA Right angle
Male connector
ANTENNA
Omni-directional (shown), or
Grid or Panel Antennas (not shown)
AMP2440
(mounted to mast with U-Bolt)
N-Male connector
Transmission Line
Low loss cable to radio room
Mast
Drip
Loop
Filter
(P/N: )
SPF-1
Coax Cable to
Pole Mounted
Amplifier
Barrel Plug
110/220 VAC
AC Main Power
110/220 VAC
AC Main Power
*
*
Filter is required in the United States when the 24dB grid dish
antenna is used in order to comply with FCC emission requirements.
N-Male to
N-Male adapter
to attach to the
N-Female on
cable
Figure 6-7. AMP 2440 Installation Details
For technical specifications, refer to Section 9.2.