User`s guide

Accessory Installation
User’s Guide
6-2
BreezeNET PRO.11 Series
6.1.1 Installing the TPA 24
1. Choose one of the TPA 24 models according to the power level at the input of
the booster. In general the NH model is used. For installations with long cables
(high attenuation), the NL model should be used.
2. Choose one of the antenna connectors to be used for transmission. This
connector is called the transmit antenna of the unit.
3. Configure the BreezeNET PRO.11 unit via a local terminal to transmit through
the transmit antenna using the Transmit Diversity parameter (see Section 3.4.3).
Figure 6-1. TPA 24 Installation
4. Connect the TPA 24 RF output directly to the transmit antenna.
5. Attach the TPA 24 RF input to the Power Inserter with the RF cable. The
Power Inserter must be installed indoors.
6. Connect the RF cable leading from the Power Inserter to the transmit antenna
on the BreezeNET PRO.11 unit.
7. Plug the power cable leading from the Power Inserter into any available
110/220V outlet. The power supply must be installed indoors.