User`s manual

PC-DS.11 & PCI-DS.11
User's Manual 51 BreezeNET DS.11 Series
The default value is Disabled.
15. Select the power mode in the Power Saving field. To allow uninterrupted data
communication, choose Disabled as the value (selected by default). Choosing Enabled
allows your notebook to enter “sleep” mode, however, this may interrupt data
communication. Consult your System Administrator to find out the best setting for your
network type.
16. Set the WEP in the WEP field, choosing 128-bit, 64-bit or Disabled. The WEP settings
must match those of the Access Point. The default value is Disabled.
NOTE: To use WEP in a network based on the BreezeNET AP-DS.11, 64-bit must be
selected.
17. The ATIM Window value in the ATIM Window field should be set to Disabled.
18. Set the listen interval in the Listen Interval field. This value is used to indicate to the AP
how often a station in Power Save mode wakes to listen to Beacon Management Frames.
The default value is Disabled (continuously listening, never entering sleep mode).
19. After configuring the properties, click OK.
20. In the Network dialog box, click Close. Windows NT will auto-bind the new adapter with
any network protocols already installed on the system.