User`s manual

BreezeNET DS.11 Series 50 User's Manual
8. Set the I/O Base and IRQ Level. These settings should be unique and not conflict with
any other device. If needed, they can be changed in order to avoid possible conflicts with
other system devices.
9. Set the network type in the Mode field. Infrastructure Station mode allows a wireless
adapter to communicate with a network using the AP-DS.11, while Ad-Hoc and 802.11b
Ad-Hoc mode allow wireless-to-wireless communication. Ad-Hoc mode allows
peer-to-peer communication with similar wireless LAN products. The 802.11b Ad-Hoc
allows peer-to-peer communication with all 802.11b based wireless LAN products.
Consult your System Administrator for information about your network communication
type.
10. Set the ESSID in the SS ID field The ESSID can have any value, but must have the same
value as the Access Point (AP) in Infrastructure mode. In Ad-Hoc mode, all clients
should share the same ESSID.
11. Set the channel in the DS Channel field. FCC regulations require a value between 1 and
11 and ETSI between 1 and 13. For a list of frequencies see Regulatory Channel
Frequencies on page 25.
12. Set the Tx Rate (Transmit Rate) in the Tx Rate field. The Tx Rate selects the allowable
transfer rates of the wireless client. To optimize performance and range, the Tx Rate
should be set to Fully Automatic, which will automatically adjust the transfer speed for
best performance and longest range.
13. Select a RTS Threshold in the RTS Threshold field. The default value is Disabled.
14. Select a Fragmentation Threshold in the Fragmentation Threshold field. This value
defines the number of bytes used for the fragmentation boundary for directed messages.