User`s manual

BreezeNET DS.11 Series iv User's Manual
specifications for the product, or improper site preparation or maintenance. No other warranty is expressed or
implied. The Company specifically disclaims the implied warranties of merchantability and fitness for any
particular purpose.
Electronic Emission Notices
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
FCC Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a residential environment, not withstanding use in commercial, business and
industrial environments. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the equipment.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
FCC Radiation Exposure Statement
To comply with FCC RF exposure requirements in section 1.1307,a minimum separation distance of 20cm. (8
inches) is required between the antenna(s) and all persons.
Information to User
Any changes or modifications of equipment not expressly approved by the manufacturer could void the user’s