User`s manual

AP-DS.11
User's Manual 35 BreezeNET DS.11 Series
NOTE: This parameter should only be changed by an experienced user. It may be set to
Short Preamble only if all the wireless stations served by the AP also support
Short Preamble.
• The Basic Rate parameter is used to define the maximum transmission rate of the
broadcasts and control packets. Available selections are 1-2 Mbps and 102-5.5-11
Mbps. In addition, you may enable/disable the Auto Rate Fall Back option. The Access
Point will increase its transmission rate until it reaches the maximum rate within the
defined range. The AP will dynamically adapt its transmission rate to the quality of the
wireless link. The default selection is 1-2-5.5-11 (Mbps) with Auto Rate Fall Back
enabled.
6. The IP Setting tab allows you to change the IP Address and IP Mask settings.
Figure 16: SNMP Configuration Utility - IP Setting