User`s guide

Utility Configuration Windows
BreezeNET DS.11 Configuration Utility 23 User’s Guide
Note that this action does not reset the counters stored in the actual unit, but just
resets the values displayed in the screen (an exception to this are the link-specific
counters described in the next section). Therefore, if you exit the Counters tab,
after performing a reset, and reopen it at a later time the counter values are
displayed to reflect the values stored in the unit. To reset the counters in the unit,
turn off the unit and then turn it back on.
3.8.2 Link-Specific Counters
The Tx Success and Tx Fail counters displayed at the end of the counters list are
link-specific; to activate these counters for a specific link, select the MAC address
of the unit at the other end of the link and click Apply.
When you click the
button, these counters are actually reset (unlike
the other counters which are only reset on screen).
3.9 Trap Monitor Tab
Figure 17. Trap Monitor Tab