User guide

5-20
BreezeNET DS.11b User’s Guide
Manual Version 1.0
3. Click Monitor to connect to the target Base Station.
4. The monitor mode of the AP Manager window is displayed as pictured in
Figure 5-18.
You can now monitor your network.
Figure 5-18: System Information Window
System Information
The system information does not provide on-line statistics, but is primarily used
to verify the version level of the embedded software that is loaded into the Base
Station.
To display the system information for the Base Station, you must first connect to
the target Base Station (see Connecting to Base Stations).
Select the
System tab to view the system information.
!The fields
Name, Location and Contact represent the values that have been
entered in the corresponding fields of the
SNMP tab in de edit mode when
the Base Station was configured.
! If you would like to change these names, please consult the section about
configuring SNMP parameters as described in SNMP Parameters.
NOTE:
Only Base Stations in the same subnet as the management station are displayed in the list.
To investigate a link outside of the subnet, enter the specific IP address in the
Enter the IP
address of a specific
Base Station field.