User guide

B-4
BreezeNET DS.11b User’s Guide
Manual Version 1.0
Rebooting Base Stations
If a particular Base Station has stopped responding to normal bridging requests,
you can reboot (reset) the Base Station. You can reboot Base Stations either
manually on-the-spot or remotely.
Upon reboot, the Base Station will run the start-up diagnostics and start
bridging operation using the configuration parameters as they were stored in
the Base Station prior to the reboot. For “out-of-the-box” Base Stations, these
parameters will be as identified in Table A-9.
Manual Reboot
To reboot the Base Station manually on-the-spot proceed as follows:
1. Remove the cover of the Base Station (see the Getting Started guide that
came with your Base Station, for assistance if needed).
2. Locate the two small holes on the bottom of the processor module, marked
“Reset” (A) and “Reload” (B) as pictured in Figure B-43.
Figure B-43: Reset Button
3. Use a small pointed object, such as the tip of a ball-point, to press the
Reset
button.
The Base Station will restart and run the start-up diagnostics, characterized
by a LED sequence where the LEDs change color in the range Red, Amber,
Green.
4. When the Power LED is green, and other LEDs are off or flickering
(indicating LAN activity), you can mount the cover of the Base Station.
After approximately 15 seconds, the unit will start bridging operation using the
configuration parameters as they were stored in the Base Station prior to the
reboot.