User guide

Appendix A:
Start Up Configuration
Your Base Station comes with installed operating software factory. Together
with this software, the Base Station has also been loaded with a factory set
configuration, that allows for “out-of-the box” operation.
The factory-set configuration should not be confused with a “default” configuration. For example
when performing a “Reboot” or “Forced Reload” (described later in this book) the unit will NOT
return to the “factory-set” configuration.
To connect to the Base Station, the network parameters of each wireless station
should be configured to match the values as identified for the Base Station unit.
! When powering up the Base Station for the very first time, these values
should match the values listed in Table A-9 :Start-up Configuration - Base
Station.
! For normal operation these values should match the ones you identified
when configuring the Base Station unit. You are advised to record this
information on the Base Station Configuration Record in this appendix.