User guide

8-12
BreezeNET DS.11b User’s Guide
Manual Version 1.0
The value will be decreased each time the message passes a router. When the
TTL value becomes 0, the message will be rejected by the next router it meets.
By default, the value is 64.
SNMP Parameters
Most SNMP parameters (except for the System Location and System Name)
are common parameters, i.e. they should be the same for ALL Base Stations in
your network.
To set the SNMP parameters proceed as follows:
1. Make sure you are connected to the right Base Station and select the
SNMP
tab to display the SNMP parameters pictured in Figure 8-41.
Figure 8-41: Setup SNMP parameters
2. Verify and/or modify the parameters of your choice.
The recommended parameters that you should specify are:
!
Read/Write Password to restrict access to the configuration of your Base
Stations, and
!
System Name to allow easy identification of the Base Station when using
the diagnostic options of your software tools.
These and all other SNMP parameters are explained in the following
paragraphs.
3. When finished, proceed with configuring other parameters or click
OK to
save the configuration and return to the main AP Manager window.