Programming instructions

4-2
BreezeNET DS.5800 System Manual
Manual Revision: 1.0
Problem and
Indication
Possible Cause Corrective Action
No power to unit.
Power LED is off.
Power cord is not
properly connected.
Verify power cord is properly connected
to the BreezeNET unit and to the power
outlet.
Failure to establish
wireless link.
WIRELESS LINK
LED is off and unit
resets every few
minutes.
1. Power supply to units
may be faulty
2. The RB-DS.5800
units may not have the
same ESSID as the BU-
DS.5800.
1. Verify power to units.
2. Verify that all units in the network
have the same ESSID (ESSID must be
identical in all units in the WLAN; the
ESSID is case sensitive). Check that the
units are on the same channel.
3. Verify wireless link
• Set BU-DS.5800 and RB-DS.5800
units side by side.
• Power on each unit and see if a wireless
link is established (even “D” models
without their external antennas should
establish a link if placed side by side).
• If the units fail to associate, reset units
to factory default values (see page 3-22).
The units should now establish a wireless
link.
Failure to establish
wireless link (“D”
models/external
antennas)
1. Power supply to units
may be faulty.
2. Cables may be
improperly connected
3. There may be some
problem with antenna
installation.
1. Verify power to units.
2. Verify that all cables are connected
securely.
3. Refer to previous Section and verify
wireless link between the units.
4. Verify that the antenna(s) are properly
installed (see relevant section in this
manual):
• Check antenna alignment.
• Verify that antenna polarization is the
same at both ends.
• Verify that the range matches
specifications.
• Verify line-of-sight/antenna
alignment/antenna height.