Programming instructions

BreezeNET DS.5800 System Manual

Electronic Emission Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the following two

conditions:

This device may not cause harmful interference.

This device must accept any interference received, including interference that may cause undesired

operation.

FCC Radio Frequency Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a residential environment, not

withstanding use in commercial, business and industrial environments. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help

Changes or modifications to this equipment not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

FCC Radiation Exposure Statement

To comply with FCC RF exposure requirements in section 1.1307, a minimum separation distance of

2 m (79 inches) is required between the antenna and all persons.

Antenna Installation

WARNING: It is the responsibility of the installer to insure that when using the outdoor

antenna kits in the United States (or where FCC rules apply), only those antennas

certified with the product are used. The use of any antenna other than those certi-

fied with the product is expressly forbidden in accordance to FCC rules CFR47

part 15.204.

The installer should configure the output power level of antennas, according to country regulations

and per antenna type.

See section 2.4.9 for more information regarding setting the appropriate power level per antenna.

Information to User

Any changes or modifications of equipment not expressly approved by the manufacturer could void

the user’s authority to operate the equipment and the company’s warranty.