Programming instructions

3-12
BreezeNET DS.5800 System Manual
Manual Revision: 1.0
Figure 17: WLAN Parameters Tab (RB Units)
! Regulatory Domain - Displays the regulatory authorities in the
relevant country of use (e.g., Canada, ETSI, FCC, Japan).
! Power - Displays the current output power level at the antenna
port.
! ESSID - An ASCII string of up to 32 characters used to identify a
WLAN that prevents the unintentional merging of two co-located
WLANs. It is essential that the ESSID is set to the same value in all
Remote Bridges and Base Units that should communicate with each
other. The ESSID field is case-sensitive.
! Maximum data rate - By default, the unit adaptively selects the
highest possible rate for transmission. Under certain conditions (for
range/speed trade-off) you may decide not to use the higher rates.
Possible values are 2, 5.5 or 11 Mbps. The default value is 11 Mbps.
! Transmit diversity - The antenna diversity option, which must be
set to Antenna No. 1.
! Range - The operative range of your WLAN or Wireless Link in the
drop down list. This parameter affects the acknowledge delay time
which needs to be increased in long links. The default value is up to
5 km.
! Channel - Channel selection varies, depending on the type of unit.
For BU-DS.5800 units, select the channel that the unit will use by
selecting a value (range: 1-14, depending on your regulatory
domain) from the Channel drop down menu. Refer to Table 3-2 for
the list of corresponding frequencies.
NOTE:
In the present product release, antenna diversity is not supported; therefore, always select
Antenna No. 1.