Programming instructions

3-4
BreezeNET DS.5800 System Manual
Manual Revision: 1.0
BreezeCONFIG DS Modes
There are several BreezeCONFIG DS modes of operation; these options
are selected via the Mode menu in the BreezeCONFIG DS main window.
The selected mode(s) is indicated by a check mark in the menu.
! Unit configuration - This is the default mode and is used for
setting parameters as detailed in this manual.
! Firmware upgrade – Used for upgrading the embedded software in
managed units; refer to page 3-18 for instructions on using this
feature.
! Multiple configuration – Used for setting configuration parameters
for more than one unit simultaneously; refer to page 3-20 for
instructions on using this feature.
! Trap quick view - When set to this mode, the PC switches
automatically to the Trap Monitor tab when Unit Configuration
mode is selected.
Unit Configuration Mode
The Control Window Section
In this section, you can:
! Discover the units that are connected to the network.
! View the DS.5800 units that have been discovered by their IP
address.
! Select the units you wish to manage.
! Locate units behind a router that cannot be detected by the
autodiscovery feature
! Assign unit IP addresses based on unit MAC addresses.
! Set the SNMP Community string.
If there are many units in the managed network, you can enlarge the list
box by clicking on the horizontal line above the list; click again to toggle
back the default display state. The list box also displays the location of
each unit, as set in the Station Status dialog box.
The Tabs Section
This section consists of several tabs, each containing parameters
required for the management of the selected unit; the number of tabs
displayed varies between the type of managed unit. The different tabs
are described in the following sections. When you switch between the
tabs, the unit selection section with the selected unit address remains
displayed.