Programming instructions

3-2
BreezeNET DS.5800 System Manual
Manual Revision: 1.0
Introduction
BreezeCONFIG DS is an SNMP-based utility that provides a consistent
view of the wireless network. The system administrator can use
BreezeCONFIG DS to control a large number of DS.5800 units from a
single location. The utility can be used to manage BU-DS.5800 and
RB-DS.5800 units as well as other members of the BreezeNET family
including the BU-DS.11, RB-DS.11, AP-DS.11 and SA-DS.11. The
description in this manual, however, is limited to management and
configuration of BU-DS.5800 and RB-DS.5800 units. Refer to the
DS.5800 section of www.alvarion.com for more information on how to
use the utility with other products.
Using BreezeCONFIG DS you can:
! Assign radio channels for optimal cell operation.
! Configure units with a specified IP address.
! Set the SNMP Read/Write Community strings.
! Verify the status of all units in the network.
! Configuration of a wide range of operational parameters, including
WLAN, IP and Security parameters.
! View Tx and Rx counters.
! Obtain general information such as the Firmware version and
system name.